To Next Page

To Previous Page

Connecting the cables

1. Place the monitor in a convenient, well-ventilated location near the computer.

2. Remove the cable management clip from the back of the stand by pressing inward on one side of the

clip (1) and pulling outward on the other side of the clip (2)

3. Depending on your configuration, connect either the DisplayPort, DVI, or VGA video cable between the

PC and the monitor.

NOTE: The monitor is capable of supporting either analog or digital input. The video mode is

determined by the video cable used. The monitor will automatically determine which inputs have valid

video signals. The inputs can be selected by pressing the Input button on the front panel or through the

On-Screen Display (OSD) feature by pressing the Menu button.

●

For analog operation, connect the VGA signal cable to the VGA connector on the rear of the

monitor and the other end to the VGA connector on the computer (cable provided with select

models).

8 Chapter 3 Setting up the monitor

Questions and Answers:

Need help?

Do you have a question about the HP E201 and is the answer not in the manual?

HP E201 Specifications

General