HP E27q G5 - USB1\ 2 Connector CN106\CN104

23
2) Lift the USB up connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the circuit board footprint.
4) Solder the new component.
USB1\ 2 connector CN106\CN104
Repair the USB1\2connector:
1） Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the USB1\2 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the circuit board footprint.
4) Solder the new component.