HP E4418B User Manual

HP4402.book : chapter3.fm 30 Thu Feb 11 15:53:59 1999
Menu Reference
Front Panel Menu Reference "System/Inputs" Menu
3-30 HP E4418B User’s Guide
❖
Press this softkey to verify that the firmware checksum is
still resident in a battery-backed memory location.
❖
Press this softkey to run a self test on the measurement
assembly. Refer to “Measurement Assembly”, on page 2-70
for further information.
❖
Press this softkey to make internal voltage measurements
on the 50 MHz reference oscillator.
❖
Press this softkey to verify that the keys are functioning
correctly. Once you enter this test you are prompted to
press all the keys and verify the correct descriptions are
displayed on the screen.
❖
Press this softkey to run a test on the internal cooling fan.
❖
Press this softkey to access a menu of various front panel
display patterns.
❏
Press this softkey to make internal measurements on the
display.
❏
Press this softkey to perform a display RAM read/write
test.
❏
Press this softkey to display test patterns. Instructions
appear on the screen detailing the use of to cycle
through the various bitmaps and to end the
displays.
❖
Press this softkey to access a menu which gives you a
selection of serial interface tests to perform.
❏
Press this softkey to initiate a test which writes to the
scratch register and reads back. The test also sets the
baud rate, word length, stop bits and parity; then reads
Lithium Battery
Measure Assembly
Calibrator
Keyboard
Fan
Display
Display Assy
Display RAM
Bitmap Displays
More
Prev
Serial Interface
UART Config

HP E4418B Specifications

General

Brand	HP
Model	E4418B
Category	Measuring Instruments
Language	English