To Next Page

To Previous Page

HP4402.book : chapter4.fm 6 Fri Feb 12 15:32:45 1999

Error Messages

4-6 HP E4419B User’s Guide

-148 Character data not allowed

A discrete parameter was received but a character string or a numeric

parameter was expected. Check the list of parameters to verify that you

have used a valid parameter type.

For example, MEM:CLE CUSTOM_1.

-151 Invalid string data

An invalid string was received. Check to see if you have enclosed the

character string in single or double quotes.

For example, MEM:CLE “CUSTOM_1.

-158 String data not allowed

A character string was received but is not allowed for the command.

Check the list of parameters to verify that you have used a valid

parameter type.

For example, LIM:STAT ‘ON’.

-161 Invalid block data

A block data element was expected but was invalid for some reason. For

example, *DDT #15FET. The 5 in the string indicates that 5 characters

should follow, whereas in this example there are only 3.

-168 Block data not allowed

A legal block data element was encountered but not allowed by the

power meter at this point.

For example SYST:LANG #15FETC?.

-178 Expression data not allowed

A legal expression data was encountered but not allowed by the power

meter at this point.

For example SYST:LANG (5+2).

-211 Trigger ignored

Indicates that <GET> or *TRG, or TRIG:IMM was received and

recognized by the device but was ignored because the power meter was

not in the wait for trigger state.

-213 Init ignored

Indicates that a request for a measurement initiation was ignored as

the power meter was already initiated.

For example, INIT:CONT ON

INIT.

Get other manuals https://www.bkmanuals.com

HP E4419B User Manual

Questions and Answers: