1. To remove the display assembly from the computer:
a. Disconnect the camera cable (1) from the system board.
b. Disconnect the antenna cables from the terminals (2) on the WWAN module. The number of
antenna cables connected to the WWAN module can vary.
c. Remove the cables from the routing channel (3) along the side of the fan.
d. Disconnect the display cable (4) from the system board.
e. Disconnect the antenna cables from the terminals (5) on the WLAN module. The number of
antenna cables connected to the WLAN module can vary.
f. Remove the cables from the routing tabs (6) in the plastic bracket.
g. Remove the eight Phillips M2.5 × 5.0 screws that secure the display assembly to the computer.
h. Rotate the display to open the hinges (1).
62
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
