3. Disconnect the battery cable from the system board (see Battery on page 42).
4. Remove the power connector cable (see Power connector cable on page 47).
Remove the display assembly:
1. Disconnect the display cable (1) and remove it from the clip (2).
2. Disconnect the antenna cables from the WWAN module (3), and then remove the cables from the clip
(4).
3. Disconnect the antenna cables from the WLAN module (5) and disconnect the left display cable (6), and
then remove the cables from the clips along the side of the fan (7).
4. Remove the six Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
5. Rotate the display to open the hinges (2).
Component replacement procedures 59
To Next Page
Loading...
