Select To do this
DriveLock Passwords
●
Enable/disable DriveLock on any computer hard drive
(enabled by default).
●
Change a DriveLock user password or master password.
NOTE: DriveLock settings are accessible only when you
enter Computer Setup by turning on (not restarting) the
computer.
TPM Embedded Security Enable/disable support for Trusted Platform Module (TPM)
Embedded Security, which protects the computer from
unauthorized access to owner functions available in
Embedded Security for ProtectTools. For more information,
refer to the ProtectTools software Help.
NOTE: You must have a setup password to change this
setting.
Automatic DriveLock Enable/disable Automatic DriveLock support.
Disk Sanitizer Run Disk Sanitizer to destroy all existing data on the primary
hard drive or the drive in the upgrade bay.
CAUTION: If you run Disk Sanitizer, the data on the selected
drive is destroyed permanently.
System IDs Enter a user-defined computer asset tracking number and
ownership tag.
Diagnostics menu
Select To do this
System Diagnostics menu
●
F1 System Information—Displays the following
information:
◦
Identification information for the computer and the
batteries in the system.
◦
Specification information for the processor, cache
and memory size, system ROM, video revision, and
keyboard controller version.
●
F2 Start-up Test—Verifies the system components
needed for starting the computer.
●
F3 Run-In Test—Runs a comprehensive check on
system memory.
●
F4 Hard Disk Test—Runs a comprehensive self-test on
any hard drive in the system.
●
F5 Error Log—Displays a log file if any errors have
occurred.
96 Chapter 5 Computer Setup
To Next Page
Loading...
