d. Remove the panel (4).
4. To remove the microphone board from the display, disconnect the cable from the reverse ZIF
connector on the board (1), and then use a tool (2) to release the board from the computer.
The microphone board is available as spare part number N94622-001.
5. To remove the display transfer board from the display:
a. Disconnect the display cable from the ZIF connector (1) on the hub board.
b. Disconnect the camera cable from the ZIF connector (2) on the hub board.
c. Disconnect the smaller cable from the reverse ZIF connector on the hub board (3).
d. Release the board from the display rear cover (4). You may need to use a tool.
Display transfer boards are available as spare part numbers N08542-001 for models with an
RGB camera and N08541-001 for models with an RGB + IR camera.
Display assembly
67
To Next Page
Loading...
