Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-3 Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, M.2 2280, PCIe-NVMe 3×4, SS solid-state drive with TLC L85358-005
1 TB, M.2 2280, PCIe-NVMe 3×4, SS solid-state drive with TLC L85348-005
512 GB, M.2 2280, PCIe-3×4, SS solid-state drive with TLC L85360-005
512 GB, M.2 2280, PCIe, NVMe, SED solid-state drive with TLC L85368-005
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive L85364-005
256 GB, M.2 2280, PCIe-3×4, SS solid-state drive with TLC L85350-005
256 GB, M.2 2280, PCIe, NVMe, SED solid-state drive with TLC M07245-005
256 GB, M.2 2280, PCIe, NVMe, value solid-state drive L85354-005
128 GB, M.2 2280, SATA-3 solid-state drive with TLC L85346-005
512 GB, M.2 2280, PCIe + 32 GB, 3D Xpoint solid-state drive L85366-005
256 GB, M.2 2280, PCIe + 16 GB, 3D Xpoint solid-state drive L85356-005
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 42).
2. Remove the bottom cover (Bottom cover on page 42).
3. Disconnect the battery cable from the system board (Battery on page 43).
Remove the solid-state drive:
1. Remove the solid-state drive shield from the system board.
NOTE: The solid-state drive shield is not available as a spare part.
ENWW Component replacement procedures 45
To Next Page
Loading...
