Solid-state drive
Description Spare part number
2-TB, PCIe, NVMe, solid-state drive with TLC L41036-001
1-TB, PCIe, NVMe, solid-state drive with TLC L41032-001
512-GB, PCIe, NVMe, solid-state drive with TLC L41038-001
512-GB, PCIe, NVMe, SED solid-state drive with TLC and OPAL2 L41037-001
256-GB, PCIe, NVMe, solid-state drive with TLC L41034-001
256-GB, M.2, SATA-3, PCIe, NVMe, SED solid-state drive with TLC and OPAL2 L41033-001
256-GB, PCIe, NVMe, value solid-state drive L41035-001
128-GB, M.2, SATA-3 solid-state drive with TLC L41031-001
118-GB, PCIe, NVMe, I/O, 3D X solid-state drive L41039-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Disconnect the battery cable from the system board (see Battery on page 28).
Remove the solid-state drive:
1. Remove the slotted Torx M2.0×2.4 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid-state drive.
30 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
