Fingerprint reader module cable
NOTE: The ngerprint reader module cable is included in the Cable Kit, spare part number L41024-001.
Before removing the ngerprint reader module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 28).
Remove the ngerprint reader module cable:
1. Release the zero insertion force (ZIF) connector (1) to which ngerprint reader module cable is connected,
and then disconnect the ngerprint reader module cable from the system board.
2. Release the ZIF connector (2) to which ngerprint reader module cable is connected, and then disconnect
the ngerprint reader module cable from the ngerprint reader module.
3. Detach the ngerprint reader module cable (3) from the keyboard/top cover. (The ngerprint reader
module cable is attached to the system board with adhesive.)
4. Remove the ngerprint reader module cable (4).
Reverse this procedure to install the ngerprint reader module cable.
34 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
