TouchPad
NOTE: The TouchPad spare part kit does not include the TouchPad cable. The TouchPad cable is included in
the Cable Kit, spare part number L41024-001-001.
NOTE: The TouchPad spare part includes rubber padding.
Description Spare part number
Equipped with NFC module antenna (includes adhesive) L41020-001
Not equipped with NFC module antenna L42312-001
Before removing the TouchPad, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 28).
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the system board.
2. Detach the TouchPad cable (2) from the keyboard/top cover. (The TouchPad cable is attached to
the keyboard/top cover with adhesive.)
3. Release the ZIF connector (3) to which the NFC module antenna cable is connected, and then disconnect
the NFC module antenna cable from the NFC module.
4. Detach the NFC module antenna cable (4) from the keyboard/top cover. (The NFC module antenna cable is
attached to the keyboard/top cover with adhesive.)
5. Remove the six Phillips M2.0×2.4 screws (5) that secure the TouchPad to the keyboard/top cover.
Component replacement procedures 39
To Next Page
Loading...
