NFC module
NOTE: The NFC module spare part kit does not include the NFC module cable. The NFC module cable is
included in the Cable Kit, spare part number L41024-001-001.
Description Spare part number
NFC module L41023-001
Before removing the NFC module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 28).
Remove the NFC module:
1. Release the ZIF connector (1) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the system board.
2. Detach the NFC module cable (2) from the keyboard/top cover. (The NFC module cable is attached to
the keyboard/top cover with adhesive.)
3. Release the ZIF connector (3) to which the NFC module antenna cable is connected, and then disconnect
the NFC module antenna cable from the NFC module.
4. Detach the NFC module (4) from the keyboard/top cover. (The NFC module is attached to the keyboard/
top cover with adhesive.)
5. Remove the NFC module and cable.
Reverse this procedure to install the NFC module.
Component replacement procedures 37
To Next Page
Loading...
