Removing and installing an M.2 SSD storage card
NOTE: There are two M.2 SSD sockets on the system board. The computer supports 2230 and 2280 M.2 SSD
cards.
1. Prepare the computer for disassembly (Preparation for disassembly on page 18).
2. Remove the access panel (Access panel on page 19).
3. Remove the front bezel (Front bezel on page 20).
4. Rotate the drive cage to its upright position (Drive cage on page 41).
5. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
Drives 45
To Next Page
Loading...
