Installing and removing a stand
Two stands are available for the computer:
●
Height-adjustable/recline stand
●
Tilt/swivel stand
Installing and removing a height-adjustable/recline stand (optional)
Installing a height-adjustable/recline stand
To install the stand:
1. Place the computer face down on a soft flat surface. HP recommends that you set down a
blanket, towel, or other soft cloth to protect the bezel and screen surface from scratches or other
damage.
2. Engage the hooks in the top of the stand in the two large holes in the top of the lower panel, and
lower the stand onto the computer.
Figure 2-11 Installing the stand
Installing and removing a stand 19
To Next Page
Loading...
