HP Engage One Retail System 145 - Attaching an Optional Fingerprint Reader to the I;O Connectivity Base

3. Connect the ngerprint reader USB cable to a USB Type-A port on the I/O connectivity base.
4. Reconnect the I/O connectivity base and computer power cords.
Attaching an optional ngerprint reader to the I/O connectivity
base
The optional ngerprint reader can be used as a standalone device or it can be attached to the I/O
connectivity base. Follow the procedure below to attach the ngerprint reader to the I/O connectivity base.
NOTE: You can attach the ngerprint reader to either side of the I/O connectivity base, but if you attach it to
the left side of the I/O connectivity base, the ngerprint reader will cover the microSD slot and the headset
jack on the I/O connectivity base.
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Place the ngerprint reader (1) on the riser (2), and then attach the mounting bracket (3) and cable
routing clip (4) to the ngerprint reader and riser with the two long screws (5) included with the
ngerprint reader.
Attaching an optional ngerprint reader to the I/O connectivity base 25