Removing the WLAN module
Description
802.11 a/b/g/n + Bluetooth 4.0, 2x2
802.11 a/b/g/n + Bluetooth 4.0, 2x2 (for use only in Indonesia)
Intel Dual Band Wireless-AC 8260
The WLAN module is secured with one screw and has two connected antennas.
To remove the WLAN module:
1. Prepare the computer for disassembly (Preparation for disassembly on page 19)
2. Remove the computer head unit from the stand (Removing and attaching the Engage One head unit to
the stand on page 27).
3. Remove the display panel from the computer head unit (Removing the display panel on page 41)
4. To remove a WLAN module, disconnect the WLAN cables (1), remove the screw (2) that secures the
module to the system board, and then slide the module out of the system board connector (3).
IMPORTANT: The WLAN cables and connectors are labeled 1 and 2. Make sure that you match the
numbered labels on the WLAN module with the numbered labels on the cables when reconnecting the
cables.
Removing the WLAN module 49
To Next Page
Loading...
