Removing and installing an M.2 solid-state drive (SSD)
IMPORTANT: If you are replacing an SSD , be sure to back up the data from the old SSD so that you can
transfer the data to the new SSD.
To remove and install an M.2 storage device:
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the computer head unit from the stand (Removing and attaching the Engage One head unit to
the stand on page 27).
3. Remove the display panel from the computer head unit (Removing the display panel on page 41)
4. To remove an SSD, remove the screw that secures the SSD to the system board (1), and then slide the
SSD out of the system board connector (2).
5. To install an SSD, slide the connector end of the SSD into the system board connector (1), and then
secure the other end of the SSD to the system board with the screw (2).
48 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
