HP Engage One Retail System 145 - Removing and Attaching the Engage One Head Unit to the Stand

Removing and attaching the Engage One head unit to the stand
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Insert a thin metal tool, such as a screwdriver, into the computer head unit release hole (1) on the stand
to depress the release button, and then pull the head unit from the stand (2).
NOTE: If a security screw is installed in the release hole, remove the screw with a T-10 screwdriver to
access the release button.
To attach the head unit to the stand, align the guide posts on the rear of the computer head unit with the
corresponding holes in the stand’s column, and then press the head unit onto the column.
Removing and attaching the Engage One head unit to the stand 27