HP Engage One Retail System 145 - Installing a 2 X 20 Customer-Facing Display (CFD)

Installing a 2 x 20 customer-facing display (CFD)
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the computer head unit from the stand (Removing and attaching the Engage One head unit to
the stand on page 27).
3. Remove the display panel from the computer head unit (Removing the display panel on page 41)
4. Remove the rubber stoppers from the CFD cable routing channel and the two CFD screw holes.
5. Route the CFD cable through the routing channel on the computer head unit (1). Pull the cable all the
way through the channel (2), and then slide the screw tabs on the CFD into the slots on the computer
head unit (3).
Installing a 2 x 20 customer-facing display (CFD) 43