Removing the MSR (Magnetic Stripe Reader)
The MSR consists of two main components that are connected together into one assembly.
To remove the MSR assembly:
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the computer head unit from the stand (Removing and attaching the Engage One head unit to
the stand on page 27).
3. Remove the display panel from the computer head unit (Removing the display panel on page 41)
4. Remove the top screw (1) and bracket (2), and then remove the bottom Phillips screw (3) and bracket (4)
from the reader.
5. Disconnect the MSR board cable from the system board (1).
TIP: Take extra care when disconnecting the cable. Pulling on the cable prematurely, before it is
disconnected, could cause damage to the connector.
6. Remove the Phillips screw (2) from the MSR board.
Removing the MSR (Magnetic Stripe Reader) 55
To Next Page
Loading...
