Solid-state drive
Description Spare part number
1-TB, 2280 M.2, PCIe3×4, NVMe solid-state drive with TLC 865697-007
512-GB, 2280 M.2, PCIe3×4, NVMe solid-state drive with TLC 847110-017
512-GB, 2280 M.2, PCIe3×4, NVMe solid-state drive 933706-002
360-GB, 2280 M.2, PCIe3×4, NVMe solid-state drive with TLC 917818-003
256-GB, 2280 M.2, PCIe3×4, NVMe solid-state drive with TLC 847109-021
256-GB, 2280 M.2, PCIe3×4, NVMe solid-state drive 933705-002
128-GB, 2280 M.2, SATA-3 solid-state drive with TLC 759848-016
128-GB, 2280 M.2, SATA-3 solid-state drive 827560-044
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Disconnect the battery cable from the system board (see Battery on page 33).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.4 screw (1) that secures the drive to the keyboard/top cover.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
34 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
