Wireless antenna
NOTE: The Wireless Antenna Kit includes the left and right wireless antenna cables and transceivers.
Description Spare part number
For use only on computer models equipped with a graphics subsystem with discrete memory 937093-001
For use only on computer models equipped with a graphics subsystem with UMA memory 936025-001
Before removing the wireless antenna, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Remove the bottom cover (see Bottom cover on page 30), and then remove the following components:
a. Battery (see Battery on page 33)
b. Solid-state drive (see Solid-state drive on page 34)
c. WLAN module (see WLAN module on page 35)
d. Fans (see Fans on page 38)
e. System board (see System board on page 47)
Remove the wireless antenna:
1. Release the tape (1) that secures the wireless antenna cables to the keyboard/top cover.
2. Detach the wireless antenna transceivers (2) from the keyboard/top cover. (The wireless antenna
transceivers are attached to the keyboard/top cover with double-sided adhesive.)
Component replacement procedures 57
To Next Page
Loading...
