TouchPad
NOTE: The TouchPad spare part kit does not include the TouchPad bracket or TouchPad cable. The TouchPad
bracket is available using spare part number 928466-001. The TouchPad cable is available using spare part
numbers 928451-001 (for use only on computer models equipped with a graphics subsystem with discrete
memory) and 928452-001 (for use only on computer models equipped with a graphics subsystem with UMA
memory).
Description Spare part number
ClickPad in natural silver nish 928488-001
ClickPad in silk gold nish 928487-001
SecurePad in natural silver nish 928490-001
SecurePad in silk gold nish 928489-001
Before removing the TouchPad, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Remove the battery (see Battery on page 33).
Remove the TouchPad:
1. Release the ZIF connector (1) to which TouchPad cable is connected, and then disconnect the TouchPad
cable from the system board.
2. Release the piece of tape (2) that secures the TouchPad cable to the keyboard/top cover.
3. Release the piece of tape (3) that secures the TouchPad to the keyboard/top cover.
4. Remove the ve Phillips PM2.0×2.3 broad head screws (4) that secure the TouchPad to the keyboard/top
cover.
5. Remove the TouchPad bracket (5) .
Component replacement procedures 45
To Next Page
Loading...
