Power connector cable
Description Spare part number
Power connector cable 808155-020
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Disconnect the battery cable from the system board (see Battery on page 33).
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Remove the Phillips PM2.5×5.7 screw (2) that secures the right I/O bracket to the keyboard/top cover.
3. Remove the two Phillips PM2.0×2.0 broad head screws (3) that secure the right I/O bracket to the
keyboard/top cover.
4. Remove the right I/O bracket (4).
The right I/O bracket is available using spare part number 928468-001.
5. Remove the power connector cable (5).
Reverse this procedure to install the power connector cable.
40 Chapter 5 Removal and replacement procedures
To Next Page
Loading...
