3. Remove the display panel (see Display panel on page 26).
4. Remove the system board (see System board on page 43), and then turn it over.
5. To remove a memory module, press outward on the two latches on each side of the SODIMM (1), then
pull the SODIMM out of the socket (2).
6. To install a memory module, position the notch (1) correctly into the socket, slide the SODIMM into the
socket at approximately a 30° angle (2), then press the SODIMM down (3) so that the latches lock it in
place.
NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab
on the memory socket.
The computer automatically recognizes the additional memory when you turn on the computer.
48 Chapter 4 Removal and Replacement Procedures
To Next Page
Loading...
