Wireless antennas
The wireless antennas route from the WLAN module via routing paths to transceivers at the top of the
computer. The antenna cables route along a similar path as the speaker cables. The transceivers are secured
to the computer with adhesive.
To remove the antennas:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 17).
2. Remove the bezel (see Bezel on page 23).
3. Remove the display panel (see Display panel on page 26).
4. Disconnect the antenna cables from the WLAN module (1).
5. Peel the transceivers o the computer (2).
6. Remove the antenna cables from the routing path at the top of the computer (3).
To install the antenna cables and transceivers, reverse the removal procedures.
When connecting the antennas cables, connect the white cable to the ‘Main’ connector on the module and the
black cable to the ‘Aux’ connector on the module.
38 Chapter 4 Removal and Replacement Procedures
To Next Page
Loading...
