HP EVA P6000 Reference Guide

Attaching the rails
1. Position left and right rack rails at the desired 'U' position in the rack, and adjust the rails to
fit the rack as needed (1, Figure 4 (page 8)).
2. Secure rack rails to the front and back rack columns using screws. Make sure that the shoulders
of the screws fit inside the square or round holes of the rack (2, Figure 4).
NOTE: If installing rails in a square hole rack, use larger-sized shoulder screws and pins for
mounting. If installing rails in a round hole rack, use smaller-sized shoulder screws and pins
for mounting.
Figure 4 Secure rack rails
8 Installing disk enclosures into the expansion rack

HP EVA P6000 Specifications

General

Model	HP EVA P6000
Number of Storage Controllers	2
Management Software	HP Command View EVA
Drive Types	SAS, SSD
RAID Levels	RAID 0, 1, 5, 6
Connectivity	8 Gb Fibre Channel, 10 Gb iSCSI, 1 Gb iSCSI
Form Factor	Rack-mounted
Storage Controller Type	Dual controllers