HP f450x - Parking Mode; Park Recording

26
3.5 Parking Mode
To monitor the vehicle when it is parked, you can activate Park Recording,
or Collision Detection, or Timelapse.
Before you activate Parking Mode, we commend to install ACC cable
through professional car service shop.
Follow the steps below to change the settings for Parking Mode:
1. Press the button to enter the OSD menu.
2. Press the / button to select Parking Mode, and then
press the
OK
button for entering function menu.
3. Press the / button to configure Parking Mode (Park
Recording / Collision Detection / Timelapse/ Off), and then press
the
OK
button to complete setting.
4. Press the button to return recording screen.
Note: ACC cable is not included in the package. Please ask for more information from your
distributor.
3.5.1 Park Recording
- In normal recording, press and hold Power key for 3 seconds, the
screen will show message “Press OK key to power off or enter
Park Recording after 10 sec.” Please wait for 10 seconds and the
camcorder will enter Park Recording automatically. The
camcorder will turn off the screen temporarily, but still in
recording status. Once the collision or vibration is detected, it will
automatically trigger emergency recording.
- To disable this function, press any key to wake up the screen and
resume to normal loop recording.
Note:
1. The video file taken in this mode is same as normal loop recording mode. It will be saved in the
“Video” folder. And the emergency file will be saved in the “Event” folder.
2. The file size is according to Record Interval setting.