HP f450x - Collision Detection; Timelapse

27
3.5.2 Collision Detection
- In normal loop recording mode, press and hold Power key for 3
seconds, the screen will show message “Press OK to power off or
enter Collision Detection after 10 sec.” Please wait for 10
seconds and the camcorder will enter Collision Detection
automatically. The camcorder will turn off the screen temporarily,
but still in standby detection status. When the camcorder detects
any motion in front of lens or any vibration/collision, the video
recording will be triggered and the event will be recorded.
- To disable this function, press any key to wake up the screen and
resume to normal loop recording.
Note:
1. The video file taken in this mode will be saved in the “Event” folder.
2. The file size is according to Record Interval setting.
3.5.3 Timelapse
- In normal loop recording mode, press and hold Power key for 3
seconds, the screen will show message “Press OK to power off or
enter Timelapse after 10 sec.” . Please wait for 10 seconds and
the camcorder will enter Timelapse automatically. The camcorder
will turn off the screen temporarily, but in timelapse recording
status.
- To disable this function, press any key to wake up the screen and
resume to normal loop recording.
Note:
1. The video file taken in this mode will be saved in the “Video” folder.
2. In this mode, the camcorder is continuously recording by one second one frame. For example,
30 minutes recording will be saved in one minute.
3. The file size is according to Record Interval setting.