13
2.5 Initial Settings
2.5.1 Set the Date and Time
We recommend to set up date and time before initial use.
To set the correct date and time, do the following:
1. In the recording screen, long press button to enter the OSD
menu.
2. Press a few times to select [Setting] card, and press to
enter.
3. Long press two times to System option, press a few times
to Date/Time setting, and press to enter.
4. Press and to adjust the value. When finish, press
to confirm and enter to next column.
5. Repeat 4 until all the value is set.
6. Long press to return to previous sub-menu.
7. Long press once again to return to Menu. Press a few
times to select [REC] card, and press to enter recording
mode.
Note:
1. In the recording mode, if you long press to enter the Menu, the car
camcorder will stop recording. Please make sure you are ready to stop recording.
2. To ensure accurate date/time stamped on the file, you are recommended to re-set
up date/time if the car camcorder is consumed battery or not in use for over 7 days.
To Next Page
Loading...
