LED Sequence Cause Action required
Ready is OFF, others are
ON.
Firmware is being
reprogrammed.
None.
Do not reset or power cycle the drive.
Clean FLASHES.
The drive requires
cleaning.
Load the Ultrium cleaning cartridge. For
supported cartridges and instructions.
If the Clean LED is still flashing when you load a
new or known good data cartridge after cleaning,
call for service.
Ready FLASHES and
Clean is ON.
Cleaning is in progress.
None. The cleaning cartridge will eject on
completion.
The cleaning cycle can take up to 5 minutes to
complete.
Table Continued
24 Operating and using the Ultrium 8 tape drive
To Next Page
Loading...
