Proprietary and Confidential MKT-0102-AI Rev 00 page 2 of 10
Contents
1. Purpose ...................................................................................................................3
2. Prerequisites............................................................................................................3
3. Estimated installation time .......................................................................................3
4. Pre-installation .........................................................................................................3
5. Procedure ................................................................................................................3
Disassembling the press ....................................................................................................... 3
Removing the old pulley ........................................................................................................ 4
Installing the new pulley ........................................................................................................ 5
6. Test procedure.........................................................................................................9
7. Parts list ...................................................................................................................9
8. Materials disposition ................................................................................................9
9. Attached documents ................................................................................................9
List of figures
Figure 1 Compressor floor assembly (shown installed) ................................................4
Figure 2 Tools for loosening the motor mounts..............................................................4
Figure 3 Removal of vacuum/blower pump pulley (shown uninstalled for clarity)..........5
Figure 4 Assembly and installation of the pulley on the vacuum/blower pump..............5
Figure 5 Positioning of the outer pulley relative to the inner pulley................................6
Figure 6 Placement of the straight edge ........................................................................6
Figure 7 Touching the motor pulley................................................................................7
Figure 8 Rotation of the motor........................................................................................7
Figure 9 Final alignment of both pulleys.........................................................................7
Figure 10 Checking belt tension.....................................................................................8
To Next Page
Loading...
