HP Integrity rx2600 - Page 118

3–44 HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
System Configuration
Simple Commands
6LPSOH,30,FRPPDQGVDOORZ\RXWRFRQWUROWKH%0&LQWHUIDFHYLHZORJVJHWKHOSDQGFKDQJH
\RXUSDVVZRUG
7RH[HFXWHVLPSOH%0&FRPPDQGV
 7\SHWKHFRPPDQGIROORZHGE\DQ\UHTXLUHGRSWLRQV7KHWDEOHEHORZGHVFULEHVWKHVLPSOH
FRPPDQGV
 3UHVV
Enter

 ,ISURPSWHGIRUDGGLWLRQDOLQIRUPDWLRQHQWHULWWKHQSUHVV
Enter
)RUH[DPSOH
cli> c
Type the new password> ****
Retype the new password> ****
New password confirmed.
cli>
Command Syntax Options Mode Description
C
Prompts user for
new password
User Allows user to change the password.
FPL
N/A User Reads the forward progress log. This log is
encoded and can be used by HP support
representatives. For additional information see
“SEL and FPL Log Entries” on page D-4.
H
N/A User Displays list of BMC commands.
INFO
N/A User Displays the BMC firmware revision.
LOC [0, 1]
0=off
1=on
User Turns the system locator LED on or off.
P [0, 1]
0=off
1=on
User Forces system power on or off; does not shut
down using OS procedures. If you do not enter a
parameter, displays the current power state.
Q
N/A User Logs out user; does not close BMC session.
RS
N/A User Resets the system.
SD
N/A User Displays the SDR repository. This data is
encoded according to the IPMI spec and can be
used by HP support representatives.
SE
N/A User Displays system event log (SEL). This log is
encoded and can be used by HP support
representatives. For additional information see
“SEL and FPL Log Entries” on page D-4.