[Blade]
Enclosure/ Usage/ CPU Memory Use Par Pending
Blade Status* OK/ (GB) On Num Deletion
Indicted/ OK/ Next
Deconf/ Indicted/ Boot
Max Deconf
========== ======================= ========= =============== ==== === ========
1/1 Active Base /OK 8/0/0/8 128.0/0.0/0.0 yes 1 no
1/2 Active Base /OK 8/0/0/8 128.0/0.0/0.0 yes 1 no
* D-Deconfigured I-Indicted
[IOBay]
Enclosure/ Usage/ Par Pending
IOBay Status* Num Deletion
========== ======================= === ========
* D-Deconfigured I-Indicted
Verifying newly created nPartitions using the OA GUI
To verify that the partitions are defined as desired, select the nPartition from the Complex nPartitions
table, and then click the Status tab.
Figure 8 nPartition Status Information
Removing an nPartition
This section describes the procedure to remove an nPartition using both the OA interfaces.
Removing an nPartition using the OA CLI
The parremove command removes an existing nPartition by unassigning all blades and I/O bays
from the nPartition. The target nPartition must be inactive unless the -F option is used. By default,
the current partition specification (parspec) associated with the nPartition is not removed when
the nPartition is removed. The current parspec associated with the nPartition becomes an alternate
42 Creating and configuring nPartitions
To Next Page
Loading...
