Verifying newly created nPartitions using the CLI
To verify that the partitions are defined as desired, perform either of the following steps:
• The parstatus –P command displays the summary data, as shown:
parstatus -P
[Partition]
Par State/ Status* # of # of ILM/ Partition Name
Num RunState Blades IOBays SLM (first 15
(GB)** characters)
=== ======================= ======= ====== ====== ============= ===============
1 Inactive /DOWN OK 2 0 32.0/224.0 nPar0001
2 Inactive /DOWN OK 1 1 16.0/112.0 nPar0002
3 Inactive /DOWN OK 1 1 16.0/112.0 nPar0003
* D-Degraded
** Actual allocated for Active and User requested for Inactive partitions
• The parstatus –V –p {partition_id} command displays information about a partition.
For the first nPartition, either use parstatus –Vp1 or parstatus –V –p nPar0001, as
shown:
User Specified Max number of vpars : 16
[Partition]
Partition Number : 1
Partition Name : nPar0001
Current Parspec Name : ps0001
Parspec Name at next boot :
State : Active
RunState : EFI
OS Type : HPUX_11iV3
OS Type at next boot : HPUX_11iV3
Hyper Threading at activation : Enabled
Hyper Threading at next boot : Enabled
Active ILO : 1/1/0/2/2
Firmware Revision : 1.0.30
Total Good Memory Size : 256.0 GB
Total Memory Available : 256.0 GB
Total Interleave Memory : 30.0 GB
Total SLM : 224.0 GB
SLM at next boot : 224.0 GB
ILM granule size : 1024 MB
ILM granule size at next boot : 1024 MB
SLM granule size : 1024 MB
SLM granule size at next boot : 1024 MB
Max number of ILM granules possible : 1024
Max number of SLM granules possible : 1024
User Specified Max number of blades : 8
Max number of blades at next boot : 8
User Specified Max number of vpars : 16
Max number of vpars at next boot : 16
Current boot mode : npars
Next boot mode : npars
Parspec Change Policy : Enabled
VGA : Enabled
VGA next boot mode : Enabled
Pending Deletion : no
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
Verifying newly created nPartitions using the CLI 41
To Next Page
Loading...
