Figure 20 Active/EFI prompt State of vPar
Getting a Console using the CLI
To access the system console of a partition using the command line, run the CO command. It can
be used either with the partition’s ID or without it as shown:
co
Partition Partition
Number Name
--------- ---------
1 nPar0001
2 nPar0002
2:1 nPar0002:vPar0001
Q) Quit
Select partition number: 2:1
----Log Snippet---------
----Log Snippet---------
Welcome to the Superdome 2 console
<use <Ctrl-b> to exit.>
Shell>
Alternatively, you can also use the CONNECT PARTITION command to connect to a partition.
connect partition 2
----Log Snippet---------
----Log Snippet---------
Welcome to the Superdome 2 console
<use <Ctrl-b> to exit.>
Getting a Console using the GUI
To access the system console of a partition using the GUI, select the Remote Console tab, and then
click on the Remote Serial Console link.
Booting to UEFI and preparing for Operating System installation 55
To Next Page
Loading...
