HP JD320B User Manual

To do… Use the command… Remarks
Configure the source IP address of
probe packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Configure optional parameters
See “Configuring optional
parameters for an NQA test
group”
Optional
Configuring threshold monitoring
Configuration prerequisites
Before you configure threshold monitoring, complete the following tasks:
• Configure the destination address of the trap message by using the snmp-agent target-host
command. For more information about the snmp-agent target-host command, see the Network
Management and Monitoring Command Reference.
• Create an NQA test group and configure the related parameters.
Configuring threshold monitoring
Follow these steps to configure threshold monitoring:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view nqa entry admin-name operation-tag —
Enter test type view of the test
group
type { dhcp | dlsw | dns | ftp | http | icmp-echo
| snmp | tcp | udp-echo | udp-jitter | voice }
—
Configure to send traps to the
network management server under
specified conditions
reaction trap { probe-failure
consecutive-probe-failures | test-complete |
test-failure cumulate-probe-failures }
Configure a reaction entry for
monitoring the probe duration of a
test (not supported in UDP jitter and
voice tests)
reaction item-number checked-element
probe-duration threshold-type { accumulate
accumulate-occurrences | average | consecutive
consecutive-occurrences } threshold-value
upper-threshold lower-threshold [ action-type
{ none | trap-only } ]
Configure a reaction entry for
monitoring the probe failure times
(not supported in UDP jitter and
voice tests)
reaction item-number checked-element probe-fail
threshold-type { accumulate
accumulate-occurrences | consecutive
consecutive-occurrences } [ action-type { none |
trap-only } ]
Required
Configure to send
traps.
No traps are sent to
the network
management server
by default.
25

HP JD320B Specifications

General

Brand	HP
Model	JD320B
Category	Switch
Language	English