EasyManuals Logo

HP JD320B User Manual

HP JD320B
189 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
Task Remarks
Applying PoE profile
Optional
Upgrading PSE processing software in service
Optional
CAUTION:
Before configuring PoE, make sure that the PoE power supply and PSE are operating properly.
Otherwise, you cannot configure PoE or the configured PoE function does not take effect.
Turning off the PoE power supply during the startup of the device might cause the PoE configuration
in
the PoE profile to be invalid.
Enabling PoE for a PoE interface
The system does not supply power to or reserve power for the PDs connected to a PoE interface if the PoE
interface is not enabled with the PoE function.
You are allowed to enable PoE for a PoE interface if the PoE interface will not result in PoE power overload.
Otherwise, whether you can enable PoE for the PoE interface depends on whether the PoE interface is
enabled with the PoE power management function (for more information about the PoE interface power
management function, see “Configuring PoE interface power management.”).
If the PoE interface is not enabled with the PoE power management function, you are not allowed
to enable PoE for the PoE interface.
If the PoE interface is enabled with the PoE power management function, you are allowed to enable
PoE for the PoE interface (Whether the PDs can be powered depends on other factors, for example,
the power supply priority of the PoE interface.)
The PSE supplies power for a PoE interface in the following modes:
Over signal wires: The PSE uses the pairs (1, 2, 3, 6) for transmitting data in category 3/5 twisted
pair cables to supply DC power while transmitting data to PDs.
Over spare wires: The PSE uses the pairs (4, 5, 7, 8) not transmitting data in category 3/5 twisted
pair cables to supply DC power to PDs.
NOTE:
When the sum of the power consumption of all powered PoE interfaces on a PSE exceeds the maximum
power of the PSE, the system considers the PSE to be overloaded. The maximum PSE power is decided
by the user configuration.
A PSE can supply power to a PD only when the selected power supply mode is supported by both the
PSE and PD. If the PSE and PD support different power supply modes (for example, the PSE does not
support power over spare wires, but the PD supports power over spare wires), you have to chan
g
e the
order of the lines in the twisted pair cable to supply power to the PD.
HP A3100 v2 EI Switch Series only support for signal mode.
Follow these steps to enable PoE for a PoE interface:
74

Table of Contents

Other manuals for HP JD320B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP JD320B and is the answer not in the manual?

HP JD320B Specifications

General IconGeneral
BrandHP
ModelJD320B
CategorySwitch
LanguageEnglish

Related product manuals