Remote management To establish a browser-based connection from a remote client using the
HP Lights-Out 100 (LO100) or HP Integrated Lights-Out 2 (iLO 2)
interface.
For more information, see “Planning for installation” on page 17.
IMPORTANT:
An IP address can be substituted for a storage server's serial number and hyphen when using either remote
browser or Remote Desktop methods to access the HP Storage Server Management console. For example:
192.0.0.1 can be substituted for TWT08466-.
Using the direct attach method
You can access the HP Storage Server Management console using a monitor, mouse, and keyboard
directly attached to the storage server.
To connect the storage server to a network using the direct attach method
1. Log on to the HP ProLiant Storage Server with the default user name administrator and the
password hpinvent.
The HP ProLiant Storage Server Management console and Rapid Startup Wizard will start
automatically.
NOTE:
You can change the administrator name and password when you configure the server using
the Rapid Startup Wizard.
2. To complete network configuration using the Rapid Startup Wizard, see
“Configuring the server on the network” on page 30.
Using the remote browser method
The storage server ships with DHCP enabled on the network port. If the server is placed on a
DHCP-enabled network and the serial number of the device is known, the server can be accessed
through a client running Internet Explorer 5.5 (or later) on that network, using the TCP/IP 3202 port.
IMPORTANT:
Before you begin this procedure, ensure that you have the following:
• Windows-based PC loaded with Internet Explorer 5.5 (or later) on the same local network as the storage
server
• DHCP-enabled network
• Serial number or IP address of the storage server
To connect the server to a network using the remote browser method, you must first ensure that the
client is configured to download signed ActiveX controls.
To enable ActiveX controls
HP ProLiant Storage Server 23
To Next Page
Loading...
