and select Server management. In the ProLiant Essentials Software section, select HP Integrated
Lights-Out 2 (iLO 2) Standard Firmware.
Configuring the server on the network
Before you begin
When first powering on the storage server you need to have some configuration data readily available
to complete the Running the Rapid Startup Wizard. Complete the Server configuration worksheet and
use the data collected to initialize the storage server.
NOTE:
Ensure you are logged into the HP ProLiant Storage Server as a local or domain administrator.
Table 5 Server configuration worksheet
Configuration Worksheet
Administrative Identity
Change system administrator's user name, which is set by default to
administrator.
User name
Change system administrator's password, which is set by default to
hpinvent.
User password
Alert E-mail Notification
E-mail address for critical, warning, or informational messages about
server status.
E-mail address alert sent to
Must be a valid, well-formed e-mail address that will appear as the
sender of server status e-mail alerts.
E-mail address alert sent from
Must be an e-mail server on your network that supports the Simple
Mail Transfer Protocol (SMTP).
SMTP server name or IP
address
SNMP Settings (to be completed only if needed)
System administrator for the storage server. The contact and location
will be provided to any SNMP management computer that requests
them.
Contact person
Any text string, such as a location or phone number. For example,
Floor #3, Financial Services Bldg.
System location
The community name is used for network authentication when sending
outgoing SNMP messages.
Community name No. 1
The IP address of a management computer that will receive SNMP
messages from the storage server using the above community name.
Trap destination No. 1
Same as above.Community name No. 2
Same as above.Trap destination No. 2
Installing and configuring the server30
To Next Page
Loading...
