3. Log on to the HP ProLiant Storage Server Management console with the default user name
administrator and the password hpinvent.
NOTE:
You can change the administrator name and password when you configure the server using
the Rapid Startup Wizard.
4. To complete network configuration using the Rapid Startup Wizard, see
“Configuring the server on the network” on page 30.
IMPORTANT:
If you are using the remote browser method to access the HP Storage Server Management console and
Rapid Startup Wizard, always close the remote session before closing your Internet browser. Closing the
Internet browser does not close the remote session. Failure to close your remote session impacts the limited
number of remote sessions allowed on the storage server at any given time.
Connecting to the storage server permits you to access the HP Storage Server Management console
(Figure 2). From the console, you can access snap-ins that allow complete server system management.
Figure 2 HP Storage Server Management console
Using the Remote Desktop method
Remote Desktop provides the ability for you to log onto and remotely administer your server, giving
you a method of managing it from any client. Installed for remote administration, Remote Desktop
allows only two concurrent sessions. Leaving a session running takes up one license and can affect
other users. If two sessions are running, additional users will be denied access.
To connect the storage server to a network using the Remote Desktop method
1. On the PC client, select Start > Run. At Open, type mstsc, then click OK.
HP ProLiant Storage Server 25
To Next Page
Loading...
