HP ML110 - ProLiant G5 2TB Storage Server NAS - SAS and SATA Hard Drive Leds

StatusDescriptionItem
N/A
PCI Express and PCI-X
non-hot-plug expansion slots
2
N/A
Hot-plug power supply
(primary)
3
N/AT-15 Torx screwdriver4
N/ANIC connector 25
N/ANIC connector 16
N/AiLO 2 connector7
N/ASerial connector8
N/AUSB connectors (two)9
N/AMouse connector10
N/AKeyboard connector11
N/AVideo connector12
Blue = Activated
Rear UID button and LED13
Flashing blue = Server remotely managed
Off = Deactivated
Both off = No AC power to any power supplyFail LED (amber)14
Fail LED flashing amber, Power LED off = Power supply failure (over
current)
Power LED (green)15
Fail LED amber, Power LED off = No AC power to this power supply
Fail LED off, Power LED flashing green = AC power present, standby
mode
Fail LED = off, Power LED green = Normal
Green or flashing green = Network activity
Activity LED16
Off = No network activity
Green = Linked to network
Link LED17
Off = Not linked to network
SAS and SATA hard drive LEDs
The following figure shows SAS/SATA hard drive LEDs. These LEDs are located on all HP ProLiant
hot plug hard drives.
Server components46