HP MSA 1050 - User Manual

MSA 1050 User Guide
Firmware Version: VE100
Part Number: Q2R18-62010
Published: Se
ptember 2017
Edition: 1
Abstract
This document describes initial hardware setup for HPE MSA 1050 controller enclosures, and is intended for use by
storage system administrators familiar with servers and computer networks, network administration, storage system
installation and configuration, storage area network management, and relevant protocols.

HP MSA 1050 Specifications

General

Brand	HP
Model	MSA 1050
Category	Enclosure
Language	English

Summary

Overview

MSA 1050 Controllers

Details the host interface protocols supported by the controller modules.

Components

MSA 1050 Controller Module-Rear Panel Components

Details the ports and connectors on the rear of the controller modules.

Installing the Enclosures

Installation Checklist

Provides a step-by-step guide for installing enclosures and initial system setup.

Connecting Controller and Drive Enclosures

Details how to cable controller enclosures to drive enclosures for expansion.

Testing Enclosure Connections

Outlines procedures to verify that all enclosure connections are correctly established.

Powering On;Powering Off

Describes the correct sequence for powering up and shutting down the storage system.

Connecting Hosts

Host System Requirements

Lists the necessary hardware and software requirements for data hosts.

Connecting the Enclosure to Data Hosts

Guides on how to physically connect servers to the storage system's host ports.

MSA 1050 Storage Host Interface Protocols

Describes the different host interface protocols like FC, iSCSI, and SAS.

Host Connection Configurations

Illustrates various methods for connecting hosts, including direct attach and switch attach.

Connecting to the Controller CLI Port

Preparing a Linux Computer for Cabling to the CLI Port

Preparing a Windows Computer for Cabling to the CLI Port

Obtaining IP Values

Guides on how to acquire and set IP addresses for the controller's management ports.

Basic Operation

Accessing the SMU

Explains how to access the web-based Storage Management Utility (SMU).

Configuring and Provisioning the Storage System

Guides on initial setup, configuration, and provisioning using the SMU.

Troubleshooting

Fault Isolation Methodology

Describes the systematic approach to identifying and resolving faults in the system.

Basic Steps

Diagnostic Steps

Provides troubleshooting based on LED status indicators and possible fault conditions.

Controller Failure

Addresses issues related to controller module failures and cache status LEDs.

Isolating a Host-Side Connection Fault

Guides on troubleshooting connectivity issues between hosts and storage ports.

Isolating Remote Snap Replication Faults

LED Descriptions

Disk Drive LEDs

MSA 1050 Controller Module-Rear Panel LEDs (FC or 10 GbE Models)

Cache Status LED Details

Specifications and Requirements

Safety Requirements

Outlines the safety precautions and regulations for system installation.

Site Requirements and Guidelines

Site Wiring and AC Power Requirements