HP NonStop SSL User Manual

34 • Configuration HP NonStop SSL Reference Manual
Parameter Meaning
DENYIP Limits allowed remote IP addresses.
DESTIPADDR
DESTIPPORT
Sets the destination IP address and port for an EXPANDS tunnel.
DONOTWARNONERROR Log selected errors with LOGLEVEL 20 rather than as WARNING.
DYNAMICROUTINGENABLEIPV6
Causes the expected separator between the target host IP address and the target
port to be a pipe symbol ('|') instead of a colon (':'). To be used only with
ROUTINGMODE D (dynamic).
FTPALLOWPLAIN Allows plain FTP traffic when HP NonStop SSL is run in FTPS mode.
FTPCALLOW200REPLY Sets compatibility for older FTP/TLS servers when run in FTPC mode.
FTPLOCALDATAPORT
Controls the value of the local port on the NonStop system of the data connection
in FTPC mode with PASSIVE set to TRUE.
FTPMAXPORT The maximum port number HP NonStop SSL will use for FTP data connections.
FTPMINPORT The minimum port number HP NonStop SSL will use for FTP data connections.
INTERFACE
Controls the IP address HP NonStop SSL will bind to for connections made to
HP NonStop SSL.
IPMODE Specifies the TCP/IP mode (IPv4/IPv6/Dual) HP NonStop SSL will run in.
KEEPALIVE Specifies if keep alive messages are sent to TCP/IP sockets.
LOGCONSOLE Determines if log messages are written to a console.
LOGEMS Determines if log messages are written to EMS.
LOGFILE Determines if log messages are written to a file.
LOGFILERETENTION Controls the number of log files kept after rollover occurs.
LOGFORMAT Controls the format of the log messages that are written to the console or log file.
LOGFORMATCONSOLE Controls the format of the log messages that are written to the console.
LOGFORMATEMS Controls the format of the log messages that are written to EMS.
LOGFORMATFILE Controls the format of the log messages that are written to a log file.
LOGLEVEL Determines which messages will be written the log file.
LOGLEVELCONSOLE Allows setting a different log level for LOGCONSOLE output.
LOGLEVELEMS Allows setting a different log level for LOGEMS output.
LOGLEVELFILE Allows setting a different log level for LOGFILE output.
LOGMEMORY Allows regular logging of HP NonStop SSL’s memory usage to the log output.
LOGMAXFILELENGTH Controls the maximum size of the log file.
MAXSESSIONS
Limits the number of parallel connections in run modes PROXYS, PROXYC,
TELNETS.
MAXVERSION Maximum admissible SSL/TLS protocol version.
MINVERSION Minimum admissible SSL/TLS protocol version.
PASSIVE Sets the direction of the data socket connections in FTPC mode.
PEERCERTCOMMONNAME For verification of remote certificates.
PEERCERTFINGERPRINT For verification of remote certificates.
PORT The port the HP NonStop SSL server listens on for incoming connections.
PTCPIPFILTERKEY Sets the filter key to enable round robin filtering.
ROUTINGMODE
Controls how SSLOBJ routes traffic to the target, either static (default) or
dynamic (usually not needed).
SERVCERT File name of a DER encoded X.509 server certificate.
SERVKEY The private key to be used for the server certificate.

HP NonStop SSL Specifications

General

Brand	HP
Model	NonStop SSL
Category	Software
Language	English