HP NonStop SSL User Manual

HP NonStop SSL Reference Manual Configuration • 51
• Both the ORIGINAL and the EXTENDED format are primarily targeted for human readers and are subject to
change. Please do not use these when intending to parse the output programmatically but use format CSV for
that instead.
CONNECTIONINFOFORMATDETAILED
Use this parameter to specify the output format for the SSLCOM command "connections, detail"
Parameter Syntax
CONNECTIONINFOFORMATDETAILED format
Arguments
format
specifies the format to be used. Valid values are:
o EXTENDED : designates the new default output format introduced with HP NonStop SSL AAE for
connection info not exceeding 80 characters and consistency between IPv4 and IPv6.
o ORIGINAL : designates the format as used before which, for longer IPv4 and especially for IPv6 addresses
exceeds the usually available window width.
o CSV : designates output as comma-separated values, primarily targeted to simplify automated parsing of
the output.
Default
Starting with HP NonStop SSL AAE, the default format will be EXTENDED. Prior to that it was ORIGINAL, but not
configurable.
EXAMPLE
CONNECTIONINFOFORMAT ORIGINAL
Considerations
• Both the ORIGINAL and the EXTENDED format are primarily targeted for human readers and are subject to
change. Please do not use these when intending to parse the output programmatically but use format CSV for
that instead.
CONTENTFILTER
Use this parameter to configure a text file with rules which will be applied to all incoming messages in run modes
TELNETS, PROXYS and PROXYC. If a message does not match the rule set, the connection will be terminated and the
message will be discarded.
Parameter Syntax
CONTENTFILETER * | file
Arguments
*
no filtering.
file
The filename of the rule set file.
Default
If omitted, HP NonStop SSL will use a value of * (no filtering).

HP NonStop SSL Specifications

General

Brand	HP
Model	NonStop SSL
Category	Software
Language	English