HP NonStop SSL User Manual

54 • Configuration HP NonStop SSL Reference Manual
DESTIPADDR, DESTIPPORT
Use these parameters to for the configuration of an HP NonStop SSL EXPANDS process.
Parameter Syntax
DESTIPADDR ip-address
DESTIPPORT port
Arguments
ip-address
specifies the IP address of the remote end of the EXPAND line.
port
specifies the port number of the remote end of the EXPAND line.
Example
DESTIPADDR 10.0.0.13; DESTIPPORT 1202
DESTIPADDR fe80:aa::eeff:1023 ; DESTIPPORT 1202
Considerations
• The parameters should be set exactly to the original equivalent parameter values of the EXPAND line handler,
as shown by the SCF INFO LINE DETAIL command.
• The parameters are ignored with any run mode other than EXPANDS.
See also
SRCIPADDR, SRCIPPORT
DONOTWARNONERROR
Use this parameter to log selected errors with LOGLEVEL 20 rather than as WARNING. By default, all errors on
sockets result in a WARNING being displayed in the HP NonStop SSL log. Using this parameter, a log message with
LOGLEVEL 20 will be issued instead for the configured error numbers.
Parameter Syntax
DONOTWARNONERROR ErrorList
Arguments
ErrorList
specifies a list of comma-separated error numbers
Default
If omitted, HP NonStop SSL will use an empty entry.
Example
DONOTWARNONERROR 4120
Considerations
• The example shown will yield in error 4120 ("Connection reset by remote") generating a log message with
LOGLEVEL 20 rather than a WARNING.

HP NonStop SSL Specifications

General

Brand	HP
Model	NonStop SSL
Category	Software
Language	English