HP NonStop SSL - Dynamicroutingenableipv6; Ftpallowplain; Ftpcallow200 Reply

HP NonStop SSL Reference Manual Configuration • 55
DYNAMICROUTINGENABLEIPV6
This parameter is only valid in ROUTINGMODE D (dynamic routing) and must be used when IPv6 addresses are to be
used as the dynamic targets. The parameter will cause the expected separator between the target host IP address and the
target port to be a pipe symbol ('|') instead of a colon (':'). Please see parameter ROUTINGMODE for more details.
Parameter Syntax
DYNAMICROUTINGENABLEIPV6 {TRUE|FALSE}
Default
FALSE
Example
DYNAMICROUTINGENABLEIPV6 TRUE
See Also
ROUTINGMODE
FTPALLOWPLAIN
Use this parameter to specify whether HP NonStop SSL will allow unencrypted FTP sessions when running in FTPS
mode.
Parameter Syntax
FTPALLOWPLAIN boolean
Arguments
boolean
If set to TRUE or 1 or Yes, HP NonStop SSL will allow unencrypted traffic.
Default
If omitted, HP NonStop SSL will *not* allow unencrypted traffic
Example
FTPALLOWPLAIN TRUE
Considerations
• This parameter is relevant only if HP NonStop SSL is running in the FTPS mode.
FTPCALLOW200REPLY
Use this parameter to specify whether HP NonStop SSL will allow an illegal "200" response to the AUTH TLS
command sent to the remote FTP/TLS server.
Parameter Syntax
FTPCALLOW200REPLY boolean
Arguments
boolean
if set to TRUE or 1 or Yes, HP NonStop SSL will allow the illegal response.
Default