HP NonStop SSL User Manual

HP NonStop SSL Reference Manual Configuration • 59
• Do not use MD5 or SHA1 anymore! These algorithms are cryptographically broken.
See also
TRUST
KEEPALIVE
Use this parameter to specify if TCP keep alive messages should be activated for established connections.
Parameter Syntax
KEEPALIVE mode
Arguments
mode
• 1 (on) for sending keep alive messages
• 0 (off) no messages are sent
Default
By default, keep alive messages are sent (1).
LOGCONSOLE
Use this parameter to define if and to what console device HP NonStop SSL log messages are written to.
Parameter Syntax
LOGCONSOLE * | % | $0 | logdevice
Arguments
*
means that no log messages are written to a console
%
means that log messages are written to the home terminal of the HP NonStop SSL process
$0
log messages are written to $0
logdevice
log messages are written the given device (e.g. $DEV.#SUBDEV)
Considerations
• The LOGLEVEL parameter controls what messages are produced by HP NonStop SSL.
• The parameter can be changed at run time using SSLCOM, please see chapter "SSLCOM Command Interface"
for details.
Default
By default, log messages will be written to the home terminal ("%")
See also
LOGEMS, LOGFILE, LOGLEVEL

HP NonStop SSL Specifications

General

Brand	HP
Model	NonStop SSL
Category	Software
Language	English