HP NonStop SSL User Manual

50 • Configuration HP NonStop SSL Reference Manual
CONFIG2
Use this parameter to specify a second configuration file for a HP NonStop SSL process.
Parameter Syntax
CONFIG2 file2
Arguments
file2
the name of the second configuration file.
Default
If omitted, HP NonStop SSL will not use a second configuration file.
Example
CONFIG2 $DATA1.HP SSL.SSLCONF2
Considerations
• Having a second configuration file allows to store the pass phrases in a separate file with higher security
settings
• The second configuration file has precedence over the first one
• This parameter can only be specified as PARAM or on the startup line. It is not valid within a configuration file.
• Parameters specified in the configuration file can be overwritten by PARAM or startup line settings.
CONNECTIONINFOFORMAT
Use this parameter to specify the output format for the SSLCOM command "connections".
Parameter Syntax
CONNECTIONINFOFORMAT format
Arguments
format
specifies the format to be used. Valid values are:
o EXTENDED : designates the new default output format introduced with HP NonStop SSL AAE for
connection info not exceeding 80 characters and consistency between IPv4 and IPv6
o ORIGINAL : designates the format as used before which, for longer IPv4 and especially for IPv6 addresses
exceeds the usually available window width
o CSV : designates output as comma-separated values, primarily targeted to simplify automated parsing of
the output.
Default
Starting with HP NonStop SSL AAE, the default format will be EXTENDED. Prior to that it was ORIGINAL, but not
configurable.
EXAMPLE
CONNECTIONINFOFORMAT ORIGINAL
Considerations

HP NonStop SSL Specifications

General

Brand	HP
Model	NonStop SSL
Category	Software
Language	English